The wrapping cycle starts and ends at the top of the pallet; this uniquely different approach to attaching and cutting the stretch-film provides the following advantages:

Selectable top banding capability
Stabilizes the load early in the wrap cycle
Places the ending film tail at the top of the load instead of the bottom
Eliminates the need of a film clamp power source on the turntable (therefore less maintenance; no need of compressed air with hook-ups or noisy compressors)
Easier, faster and safer positioning of the load on the turntable (no clamp or other systems that can be damaged)MAIN FEATURES:
Working functions and operations controlled by a PLC, with touch-screen Operator Interface
Power Off / On – Reset switch and Power-On indicator light
Single button Auto Wrap cycle Start/Pause
Machinestatus visual indicator (run; clear or fault)
Selection among three (3) different types of wrapping : automatic / semi-automatic / top banding
Photo-eye for the automatic load height detection
Separate setting of the top and bottom wraps, from 1 to 12 revolutions;
Variable turntable speed control (adjustable from 3 to 15 rpm), with a soft start acceleration and a final revolution deceleration with positive stop alignment
Film tension control
Broken film/run-out of film detection with automatic machine reset
Separate film carriage raise and lower speed controls
Film carriage Lower/Raise buttons
Film carriage with an adjustable speed motor and driving through a belt/pulley with Anti-Fall Device.
Pre-stretch film carriage (max film width of 500 mm) with a 200% fixe ratio (1 mt = 3 mt), powered by a variable speed motor, with a fully electronic dynamic dancer corner compensation
Carriage descent obstruction shut-off device for additional safety
Side mounted film carriage for operator convenience and safety
Turntable inserted in a square-shaped frame and supported by a 36 roller bearing system (direct chain driving system, with chain tensioner)
Button for the manual control of the turntable rotation
Predisposal for lifting the machine (with a fork lift) from the front and from the rear side (holes in the basement frame)
Heavy duty frame with structural steel construction and Electro-static powder coated paint finish
Emergency Stop Button

Machine manufactured according to CE rules.

SPECIFICATIONS – ECOSPIR MATIC

Power supply: 220V – 1 PH – 50/60 Hz – 20 A
Overall dimensions: 2900 x 1800 x 2200 mm
Machine weight: 800 Kg
Turn-table diameter: 1650 mm
Maximum pallet dimensions: 1000 x 1200 x 2000 (h) mm
Maximum pallet weight: 2200 Kg
Turn-table rotation speed: between 3 and 15 wraps/min
Maximum roll width: 500 mm
Output: up to 35 pallets/hour

note: Technical data subject to variations without prior notice. Output depends from the type of pallet

Μεγέθυνση

ECOSPIR MATIC

HEAVY DUTY TURNTABLE MACHINE WITH AUTOMATIC STRETCH-WRAPPING CYCLE

To further widen the range of pallet-wrapping systems, Italdibipack Group has introduced a NEW pallet-wrapper that functions electrically (compressed air is not required) and is equipped with an exclusive cut and clamp device PAT so that the stretch-wrapping cycle is fully automatic.